|
Installation & Operating Instructions
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
AA03-050-xxx Universal Fixture Plugs
|
|
|
|
|
|
|
|
|
|
Usage of your IVB UFP requires simple preparation
of the "holding" side to accept the UFP outside diameter thread.
|
|
 |
|
|
|
|
|
|
|
Prepare the "holding" side in the following manner:
|
|
|
|
|
|
|
|
|
|
 |
|
 |
|
Drill a 15/16" (.938) diameter (thru) hole.
C'Bore 1.17/1.178" x .015R to a depth of 1.152" |
|
|
|
|
Tap(or thread) 1-1/4"-12
UNF-2B-LH to a depth of .950"
|
|
|
|
|
|
|
|
|
|
Once the "holding" side has been prepped,
simply screw your IVB UFP into the appropriate hole using the AA03-002-001
install tool (do not exceed 30 ft-lb torque). |
|
|
|
|
|
|
|
|
|
General
Your Invert-A-Bolt™ (IVB) Universal Fixturing Plug™ (UFP) is one of the primary components of the IVB universal Fixturing Concept. The UFP is a threaded insert that employs a left-hand thread on the outside diameter (OD) and a right-hand thread on the inside diameter (ID). This configuration allows the user to screw the UFP into an existing hole used for other IVB products and then to use the ID thread to screw other components into the UFP. Use your UFP to add clamps, jacks, riser blocks, edge supports and many other tooling components to your IVB Universal Fixture. Other uses of the UFP include: Use as a replacement for helical inserts with the advantage of easy instllation and remove; Use as a low cost "plug" in which fouled holes can be repaired.
|
|
|
|
|
|
|
|
|
|
Replacement Parts & Maintenance
1. Periodically remove IVB UFP, blow out hole to clean out accumulated
metal chips and debris.
|
|
|
|
|
|
|
|
|
|
Proviso's
The IVB Universal Fixturing Plug™ is not certified to any specification. If loading is a concern, you should perform your own load analysis prior to usage in an application. Shear & Tensile Load information for some Invert-A-Bolt™ products is available at the FAQ page.
|
|
|
|
|
|
|
|
|
